Yamaha TD1 owner manual

445438

439

440

441

442

443

444

EbFBb

CHROMATIC TUNER TD-1

INPUT

MIC

BATT.

POWER

KEY

CALIB

-20

-50

445438

439

440

441

442

443

444

EbFBb

CHROMATIC TUNER TD-1

INPUT

MIC

BATT.

POWER

KEY

CALIB

-20

-50

445438

439

440

441

442

443

444

EbFBb

INPUT

BATT.

-20

-50

445438

439

440

441

442

443

444

EbFBb

INPUT

BATT.

-20

-50

BATT.

-20

-50

BATT.

-20

-50

TD-1

CHROMATIC TUNER

OWNER’S MANUAL / MODE D’EMPLOI

BEDIENUNGSANLEITUNG /

TD-1

CHROMATIC TUNER

OWNER’S MANUAL

■ COMPONENTS

Thank you for purchasing the YAMAHA TD-1 Chromatic Tuner.

Please read this manual thoroughly and keep it in a safe place for

future reference.

■ PRECAUTIONS

◆To prevent damage, do not use the tuner in the following locations:

• places where the unit will be in direct sunlight;

• places subject to temperature and humidity extremes;

• places that are sandy or dusty.

◆To power the tuner, use only two CR-2025 lithium batteries.

◆For maximum battery life, always be sure the tuner is turned OFF when

not in use.

◆If an exhausted battery is left in the unit for an extended period of time,

it may leak and cause malfunctioning of the unit. When the battery

becomes exhausted, always remove it and replace it as soon as

possible.

◆Do not subject the tuner to strong physical shock or vibration. Do not

use excessive force on any of the controls.

◆Never use solvents such as benzene or thinner to clean the tuner.

Wipe clean with a soft, dry cloth.

◆After reading the owner's manual, keep it in a safe place for future

reference.

Never dispose of used batteries by burning them.

Also make sure to keep batteries away from children.

■ TUNING PROCEDURE

The tuner will automatically select the note closest to the tone input for

tuning. The accuracy of that note’s pitch (flat or sharp) is displayed by the

meter.

1.Press the POWER switch to turn the power on.

After the POWER is switched on, the indicator for the currently

selected key will light, and the currently selected standard pitch

indicator will flash for approximately 3 seconds.

2.Press the CALIB switch, and select the desired pitch (438 - 445Hz).

(See “PITCH SELECTION”.)

3.Press the KEY switch, and select the desired transposition (C, Eb, F, or

Bb). (See “TRANSPOSITION SETTING”.)

4.The indicator for the closest note played on the instrument lights. Half

tones are indicated by the # indicator.

5.When the appropriate indicator lights, continue to adjust the instrument’s

pitch until the Cent Indicator’s green center indicator lights.

* To tune instruments using an external microphone or pickup, also electric

or electronic instruments, connect a cord to the Input Jack located on the

side of the unit. (The built-in microphone cannot be used when there is a

plug in the input jack.) Play close to the microphone when tuning acoustic

instruments.

Standard Pitch Indicator Key Switch

(KEY)

Calibration Switch (CALIB)

Note Indicator

Input Jack

Built-in Microphone

POWER Switch

Cent Indicator

Transposition Indicator

(Key)

b b

9802 R3

FCC INFORMATION (U.S.A.)

1.IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

This product, when installed as indicated in the instructions contained in this

manual, meets FCC requirements. Modifications not expressly approved by

Yamaha may void your authority, granted by the FCC, to use the product.

2.IMPORTANT: When connecting this product to accessories and/or another

product use only high quality shielded cables. Cable/s supplied with this

product MUST be used. Follow all installation instructions. Failure to follow

instructions could void your FCC authorization to use this product in the

USA.

3.NOTE: This product has been tested and found to comply with the require-

ments listed in FCC Regulations, Part 15 for Class ”B” digital devices. Com-

pliance with these requirements provides a reasonable level of assurance

that your use of this product in a residential environment will not result in

harmful interference with other electronic devices. This equipment gener-

ates/uses radio frequencies and, if not installed and used according to the

instructions found in the users manual, may cause interference harmful to

the operation of other electronic devices. Compliance with FCC regulations

does not guarantee that interference will not occur in all installations. If this

product is found to be the source of interference, which can be determined

by turning the unit ”OFF” and ”ON”, please try to eliminate the problem by

using one of the following measures:

Relocate either this product or the device that is being affected by the inter-

ference.

Utilize power outlets that are on different branch (circuit breaker or fuse)

circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient the antenna. If the

antenna lead-in is 300 ohm ribbon lead, change the lead-in to co-axial type

cable.

If these corrective measures do not produce satisfactory results, please con-

tact the local retailer authorized to distribute this type of product. If you can

not locate the appropriate, please contact Yamaha Corporation of America,

Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA 90620

The above statements apply ONLY to those products distributed by

Yamaha Corporations of America or its subsidiaries.

■ SPECIFICATIONS

Indicators : Cent indicator, Note indicator,

Calibration indicator, Key indicator

Note Setting Range : A0 (27.5Hz) – C8 (4186.01Hz)

Accuracy :±1 cent

In Pitch Accuracy :±3 cent

Standard Pitch Setting Range

: A4=438 Hz – 445 Hz (1 Hz steps)

Transposition : C, Eb, F, Bb

Auto Power Off Function : After approx. 5 minutes

Other Functions : Memory backup function

Battery check function

Connector : INPUT (3.5 monaural)

Power Source : Lithium battery x 2 (CR-2025)

Battery Life : Approximately 3 hrs. (When the

microphone has continuous sound input.)

Dimensions (W x H x D) : 102 x 12 x 64 mm (4-1/8" x 1/2" x 2-1/2")

Weight (including batteries) :65 g (2.1 oz)

Accessories : Lithium battery x 2 (CR-2025),

Hard case (can be used as stand)

■ THE HARD CASE

The hard case can be used as a

stand as shown in the illustration

on the right.

■ TRANSPOSITION SETTING

This function sets the transposition or key of the instrument. It is possible

to set the transposition for instruments in the key of C, Eb, F, or Bb. The

selected key is confirmed by an indicator.

* The default setting (factory preset) is C.

◆ Transposition Setting Method

1.Press the POWER switch to turn the power on.

2.Press the KEY switch to select the instrument’s key. Each time the

switch is pressed, the key indicator will advance one step.

b b

■ PITCH SELECTION

The TD-1 can be set to standard pitches ranging from A4=438Hz to

A4=445Hz in 1Hz increments.

* The default setting (factory preset) is 442Hz.

◆ Pitch Selection Method

1.Press the POWER switch to turn the power on.

2.Press the CALIB switch once, and the indicator for the currently

selected Standard Pitch will flash. (438 - 445Hz)

3.While the indicator is flashing, press the CALIB switch. The indicators

will flash in sequence each time the pitch switch is pressed. Each

indicator step represents a 1Hz change in standard pitch.

4.When the CALIB switch has not been pressed for about 2 seconds, the

tuner will automatically return to the tuning mode.

Tune until the Center

Indicator (green) lights.

Select the

Transposition Key.

The indicator of the note being tuned lights.

■ BATTERY REPLACEMENT

◆ Battery Check

When battery power becomes

low, while the tuner is in use, the

“cent” indicators on the left and

right will flash. Replace the

batteries with a new set (CR-

2025 x 2) as soon as possible.

◆ Replacement Procedure

1.Remove the battery cover fixing screw at the bottom of the unit and

remove the battery cover by sliding it in the direction of the arrow as

shown in the illustration below.

2.Lift out the old batteries using a pointed tool (tweezers etc.).

3.Insert the new batteries with its - pole facing down (+ pole must be

visible when inserted).

4.Attach the battery cover and secure it using the fixing screw.

Lithium batteries

(CR-2025 x 2)

Bottom

side

Battery cover

Screw

Flash

■ FUNCTIONS OF THE TD-1

◆ Transposition Key

Select one of the 4 transposition settings to accommodate the tuning of

instruments in the keys of C, Eb, F, and Bb.

◆ Pitch Selection

It is possible to set the TD-1 to standard pitches ranging from

A4=438Hz to A4=445Hz in 1Hz increments.

◆ Other Functions

• Auto Power Off Function

When none of the tuner’s buttons are pressed, or there is no sound

input for approximately 5 minutes, the tuner will automatically turn off.

• Battery Check Indicator

When battery power becomes low, the left and right side “cent”

indicators will flash, indicating the battery must be replaced.

• Memory Backup Function

This function retains all current settings in memory when the unit is

turned off (POWER button or Auto Power Off).

THIS DIGITAL APPARATUS DOES NOT EXCEED

THE “CLASS B” LIMITS FOR RADIO NOISE EMIS-

SIONS FROM DIGITAL APPARATUS SET OUT IN

THE RADIO INTERFERENCE REGULATION OF THE

CANADIAN DEPARTMENT OF COMMUNICATIONS.

445

438

439

440

441

442

443

444

EbFBb

CHROMATIC TUNER TD-1

INPUT

MIC

BATT.

POWER

KEY

CALIB

-20

-50

445

438

439

440

441

442

443

444

EbFBb

CHROMATIC TUNER TD-1

INPUT

MIC

BATT.

POWER

KEY

CALIB

-20

-50