TROUBLESHOOTING

If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help.

SYMPTOM

PROBABLE CAUSE

REMEDY

 

 

 

This unit does not switch ON when the

The power cord is not connected or not

Securely connect the power cord.

POWER switch is pressed.

completely connected.

 

 

 

 

It happens that this unit does not work

There is an influence of strong external noise

Turn the power to this unit off and disconnect

normally.

(lightning, excessive static electricity, etc.) or a

the AC power cord from the AC outlet. After

 

misoperation on this unit while using this unit.

about 30 seconds have passed, connect the

 

 

power and operate this unit again.

 

 

 

The disc tray does not close completely.

A foreign object is obstructing the tray.

Carefully check the disc tray and remove the

 

 

foreign object.

 

 

 

Play does not begin.

The disc is damaged.

Check the disc carefully; replace it if

 

 

necessary.

 

 

 

 

There is moisture on the laser pickup.

Wait 20 to 30 minutes after switching the unit

 

 

ON before trying to play a disc.

 

 

 

 

The disc has been loaded upside down.

Reload the disc with the label side up.

 

 

 

 

The disc is dirty.

Clean the disc.

 

 

 

Play is delayed, or begins at the wrong

The disc may be scratched or damaged.

Check the disc carefully; replace it if

place.

 

necessary.

 

 

 

A disc cannot be played normally, or there

A nonstandardized disc is played.

Play another disc.

is a noise during play.

 

 

 

 

 

No sound or no picture.

Improper output cable connections.

Connect the cables properly. If the problem

 

 

persists, the cables may be defective.

 

 

 

 

Improper amplifier operation.

Set the amplifier controls to the correct input

 

 

selection.

 

 

 

No picture.

The setting of the VIDEO OUT MODE

Set the VIDEO OUT MODE SELECT switch to

 

SELECT switch is improper.

another proper position.

 

 

 

Sound and picture “skip”.

This unit is being subjected to vibrations or

Relocate this unit.

 

impacts.

 

 

 

 

 

The disc is dirty.

Clean the disc.

 

 

 

Sound “hums”.

Improper cable connections.

Securely connect the audio cables. If the

 

 

problem persists, the cables may be defective.

 

 

 

Noise from a nearby tuner.

The tuner is too close to this unit.

Move the tuner and this unit farther apart.

 

 

 

Noise from inside of the disc tray.

The disc may be warped.

Replace the disc.

 

 

 

The remote control transmitter does not

The batteries of this remote control transmitter

Replace the batteries with new ones.

work.

are too weak.

 

 

 

 

 

Direct sunlight or lighting (of an inverter type

Change position of the main unit.

 

of fluorescent lamp etc.) is striking the remote

 

 

control sensor of the main unit.

 

 

 

 

SPECIFICATIONS

Audio (analog) output level (only when playing CD)

Signal processing

 

1 kHz, 0 dB ................................................................

2 ± 0.5V

KEY CONTROL, ECHO

................................................ Digital

Signal to noise ratio (only when playing CD)

Power requirements

 

........................................................................

100 dB or more

China model .................................................

AC 220V, 50 Hz

Dynamic range (only when playing CD)

 

Singapore model..........................................

AC 230V, 50 Hz

..........................................................................

96 dB or more

General model....................

AC 110/120/220/240V, 50/60 Hz

Harmonic distortion + noise

 

Power consumption ........................................................

25W

1 kHz .............................................................

0.0035% or less

Dimensions (W x H x D)

......................... 435 x 116 x 403 mm

Frequency response

 

Weight ...............................................................................

6 kg

2 Hz–20 kHz ...............................................................

±0.5 dB

Accessories ...................................

Audio connection cord x 1

Video output

 

 

Video connection cord x 1

75Ω , Negative sync. ..............................................

1 terminal

 

Remote control transmitter

Video output level ........................................................

1 Vp-p

 

Batteries (size AA, R6, UM-3)

Mic input .......................................................................

2 jacks

 

 

 

 

Please note that all specifications are subject to change

 

 

without notice.

 

22