Yamaha 006IPTO-F0, WD83390

24 Chapter 2—Control Surface & Rear Panel

DM1000 Version 2—Owner’s Manual

MONITOR Section

A[DISPLAY] button

This button displays a Monitor page, enabling you to adjust monitor settings (see page 119

and 136).

B[SOLO] indicator

This indicator ﬂashes when a single or multiple channels are soloed.

C[CLEAR] button

This button “unsolos” all soloed Channels.

D[2TR D1] button

E[2TR D2] button

F[STEREO] button

These buttons select the Control Room Monitor output signal. When the [2TR D1] button

indicator is lit, the signal at the 2TR OUT DIGITAL 1 jack is selected. When the [2TR D2]

button indicator is lit, the signal at the 2TR OUT DIGITAL 2 jack is selected. When the

[STEREO] button indicator is lit, the Stereo Bus signal is selected.

If you change the parameter setting on the Monitor | C-R/TB page (see page 122), you can

monitor the OMNI IN signal, instead of the 2TR IN DIGITAL signal, when you press the

[2TR D1] or [2TR D2] button.

G[SLOT] button

H[BUS] button

These buttons select the Surround Monitor signal source. When the [BUS] button indicator

is lit, the Bus 1–8 signals are selected. When the [SLOT] button indicator is lit, the signals

from Slots 1/2 are selected. (See page 136 for more information on the Surround Monitor.)

I[DIMMER] button

This button activates the Dimmer function, which lowers the Monitor and Surround Mon-

itor signals. This function is convenient when you wish to talk in the control room during

mixdown. The [TALKBACK] button indicator ﬂashes while the Talkback function is active

(see page 120).

J[TALKBACK] button

This button turns on the Talkback function. While the button indicator is lit, the Talkback

mic signal is sent to any desired Bus or Slot (see page 123).

KMONITOR LEVEL control

This control adjusts the monitor level.

Note:

•The DM1000 allows you to patch source signals to any output jack (other than the PHONES

jack). Therefore, the console does not feature a dedicated monitor output jack. Instead, you

can route monitoring signals to any desired output jack (typically to OMNI OUT jacks

1–12).

•By default, monitoring signals are assigned to OMNI OUT jacks 11 and 12.

MONITOR

LEVEL

SOLO CLEAR

2TR D1 2TR D2

DIMMERTALKBACK

MONITOR

STEREO

SLOT BUS

DISPLAY

100

9 J K