Metering 39
DM1000 Version 2—Owner’s Manual
3
Operating Basics
Metering
This section describes how to check Input and Output Channel levels using the Meter pages
or an optional MB1000 Peak Meter Bridge.
1Press the DISPLAY ACCESS [METER] button repeatedly until the Meter | Posi-
tion page appears.
This page enables you to set the metering position for Input and Output Channels.
AINPUT section
This section enables you to select the metering position for Input Channel signals.
BOUTPUT section
This section enables you to select the metering position for Output Channel (Aux Out
1–8, Bus Out 1–8, Stereo Out) signals.
2Move the cursor to the desired parameter button in the INPUT or OUTPUT
section, then press [ENTER].
You can select one of the following three positions in each section.
•PRE EQ..........................Immediately before EQ.
•PRE FADER..................Immediately before the fader.
•POST FADER...............Immediately after the fader.
3Press the DISPLAY ACCESS [METER] button repeatedly until the page listed
below that contains the desired channels appears.
-CH1-32 page
-CH33-48 page
These pages display the Input Channel 1–32 levels and Input Channel 33–48 levels
respectively.
-CH1-48 page
This page displays the Input Channel 1–48 levels altogether.
-Master page
This page displays the Output Channel (Aux Out 1–8, Bus Out 1–8, Stereo Out) levels
altogether.
-Effect page
This page displays the internal effects processor 1–4 input and output levels altogether.
Tip: If an optional MB1000 Peak Meter Bridge is installed, changes on this page will be
reflected on the Input & Output Metering Position parameters on the Peak Meter Bridge.
1
2