Setting the Input Channels from the Display 65
DM1000 Version 2—Owner’s Manual
6
Input Channels
Gating Input Channels
To set the Input Channel gates, use the [SEL] buttons to select the desired Input Channel,
then press the DISPLAY ACCESS [DYNAMICS] button, then the [F1] button. The Dynam-
ics | Gate Edit page appears.
AKEYIN SOURCE
Select one of the following buttons to determine the trigger source for the cur-
rently-selected Input Channel’s gate.
•SELF...............................The selected channel’s own input signal is the trigger source.
•CHANNEL....................Another Channel’s input signal is the trigger source. Select the
desired channel in the parameter box below the CHANNEL
button.
•AUX................................An Aux Send signal is the trigger source. Select the desired bus
in the parameter box below the AUX button.
BSTEREO LINK
This parameter’s ON/OFF button enables you to pair gates for stereo operation even
when the Input Channels are not paired.
CCURVE
This area displays the current gate curve.
DTYPE
This area displays the current gate type (GATE or DUCKING).
EMeters
These meters indicate the levels of the post-gate signals and the amount of gain reduc-
tion.
FON/OFF
The ON/OFF button turns the currently-selected Input Channel’s gate on or off.
GPARAMETER
These controls enable you to set the gate parameters. (See page 324 for more informa-
tion on the parameters.)
Note: You cannot change the gate type on this page. To change the gate type, recall a pro-
gram that uses the desired gate type from the Gate library.
Tip: You can store the gate settings in the Gate library, which features preset programs
that can be used for various applications (see page 181).
4
5
7
6
1
3
2