104
Directly outputting an INPUT channel
LS9-16/32 Owner’s Manual
4Move the cursor to the port select popup
button, and press the [ENTER] key.
The OUTPUT PORT SELECT popup window will
appear, allowing you to select the output port that will
be patched to direct output.
1Category tab
These tabs select the output ports that are shown in the
popup window. Each tab corresponds to the following
output ports.
●OMNI / 2TR OUT
Shows OMNI OUT jacks 1–8 {1–16} and 2TR
OUT DIGITAL jack.
●SLOT {1/2}
Shows output channels 1–16 of the slot(s) {1/2}.
●REC IN
Shows USB memory recorder input channels.
BPort select button
This selects the output port that is assigned to direct
output.
5Use the category tabs and the port select
buttons to select the port that will be the
direct output.
6Move the cursor to the CLOSE button and
press the [ENTER] key to return to the pre-
vious screen.
7Move the cursor to the direct out point
select box, and use the dial or the [DEC]/
[INC] keys to select the direct out point.
You can choose PRE HPF (immediately before the
high-pass filter), PRE EQ (immediately before the
EQ), or PRE FADER (immediately before the fader).
8Move the cursor to the DIRECT OUT ON/
OFF button, and press the [DEC]/[INC] keys
or the [ENTER] key to turn it ON.
This enables the direct output you specified.
9As necessary, move the cursor to the
DIRECT OUT LEVEL knob and use the dial
or the [DEC]/[INC] keys to adjust the level of
the direct output.
LS9-16
1
2
• As an alternate method of specifying a direct output, you can
select an INPUT channel as the output source of an output
port (
→
p. 98).
HINT