Top panel
LS9-16/32 Owner’s Manual 17
2
Parts and their function
zChannel module section• • • • • • • • • • •
In this section you can operate the main parameters of the
input channels and output channels, as well as the monitor
output. Use the LAYER section ( p. 19) to select the
channels that are mapped to this section.
xST IN (stereo input) section • • • • • • • •
In this section you can operate the main parameters of the
stereo ST IN channels 1–4. The function of each control-
ler is the same as in the Channel Module section, with the
exception that the L-channel or R-channel will be alter-
nately selected as the target of operations each time you
press the [SEL] key, and the fact that the encoder rather
than the fader is used to adjust the level.
1[SEL] key
This key selects the channel to be operated. When you
press this key to make the LED light, the corresponding
channel will be selected for operations in the SELECTED
CHANNEL section or in the display. In the ST IN section,
the L-channel and R-channel will be alternately selected
as the target of operations each time you press the [SEL]
key.
B[CUE] key
This key selects the channel to be cue-monitored. When
cue is on, the LED will be lit.
CMeter LEDs
These LEDs indicate the audio signal level of the input
channel or output channel.
D[ON] key
This switches the channel on/off. The key LED will light
for channels that are on. In SENDS ON FADER mode,
this key is an on/off switch for the signal that is sent from
that channel to the currently selected MIX bus (or from a
MIX channel, to the MATRIX bus).
EFader/Encoder
This adjusts the signal level or monitor level of the input
channel or output channel. In SENDS ON FADER mode,
this adjusts the send level from that channel to the cur-
rently selected MIX bus (or from a MIX channel, to the
MATRIX bus).
1
2
4
5
3
1
2
4
5
3
1
2
4
5
3
LS9-32LS9-16