Non skid pad
To prevent the speakers from sliding around, attach the supplied pads to the four points on the bottom of each satellite speaker. Place the speaker on a stable, flat surface.
Specifications
Type .......................... | Advanced Active Servo Technology | ||
Output power |
|
|
|
Satellite speakers...... | 20 W + 20 W (1 kHz, 4 Ω | at | |
| T.H.D.=10%) |
| |
Subwoofer ................ | 40 W (100 Hz, 5 Ω at T.H.D.=10%) | ||
Input sensitivity................. | 200 mV (1 kHz, 4 Ω | at 20 W) | |
Input impedance ............... | 25 kΩ |
| |
Frequency response........... | 32 Hz to 20 kHz |
| |
Speaker unit |
|
|
|
Satellite speakers |
|
|
|
Tweeter................ | 19 mm (3/4") dome, magnetic shielding | ||
Midrange ........... | 8 cm (3") cone, magnetic shielding | ||
Subwoofer.................. | 16 cm (6.5") cone, magnetic shielding | ||
Power consumption........... | 65W |
| |
Power supply |
|
|
|
U.S.A. and Canada models | .... AC 120 V, 60 Hz |
| |
Australia model.................... | AC 240 V, 50 Hz |
| |
U.K. and Europe models...... | AC 230 V, 50 Hz |
| |
Dimensions (W ⋅ | H ⋅ D) |
Satellite speakers | ......97 (3.8") ⋅ 159 (6.3") ⋅ 178 (7") mm |
Subwoofer................. | 350 (13.8") ⋅ 210 (8.3") ⋅ 321 |
| (12.6") mm |
Weight |
|
Satellite speakers | ......0.7 kg (1 lb. 9 oz.) ⋅ 2 |
Subwoofer................. | 8.0 kg (17 lbs. 10 oz.) |
Finish |
|
Computer white | |
Black |
Accessories
3.5mm stereo mini plug cable ⋅ 1 (1.8m), RCA pin plug cable ⋅ 1 (1.8m), 8 pin plug cable ⋅ 1 (1.8m), 8 pcs of non skid pads ⋅ 1
* Specifications subject to change without notice.
Troubleshooting
If the speakers fail to operate normally, check the following table. It lists common operation errors and simple measures that you can take to correct problems. If a problem cannot be corrected, or the symptom is not listed, disconnect the AC power cord and contact your authorized YAMAHA dealer or service center for help.
FAULT |
|
|
| CAUSE |
|
|
|
| CURE |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
No sound comes | The AC power cord is not properly plugged | Insert the AC power cord firmly into the wall outlet. |
| ||||||||||
from the speakers or | into the wall outlet. |
|
|
|
|
|
|
|
|
| |||
subwoofer. | The main power switch on the subwoofer is | Set the main power switch to ON. |
| ||||||||||
|
| ||||||||||||
| set to OFF. |
|
|
|
|
|
|
|
|
| |||
| The |
|
| (standby/on) button is turned off. | Turn on the |
|
|
| (standby/on) button (the indicator |
| |||
|
|
|
|
|
|
| |||||||
|
|
|
|
| |||||||||
|
|
|
|
| lights). |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||||
| Connections are faulty or incomplete. | Make the connections again, firmly, or use a differ- | |||||||||||
|
|
|
|
| ent cable. | ||||||||
| The volume is set to minimum. | Turn the speaker VOLUME control to the right to | |||||||||||
|
|
|
|
| increase the volume. | ||||||||
|
|
|
|
| Turn the subwoofer VOLUME control to the right to | ||||||||
|
|
|
|
| increase the volume. | ||||||||
| The level of the signal being input is too low. | Turn up the volume on the connected component. | |||||||||||
| Headphones are connected. | Disconnect the headphones. | |||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Sound is distorted. | The level of the signal being input is too high. | Turn down the volume on the connected component. | |||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Noise. | Connections are faulty or incomplete. | Make the connections again, firmly, or use a differ- | |||||||||||
|
|
|
|
| ent cable. | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Noise is heard when | The power cord of this unit connected to | Connect the power cord to an UNSWITCHED AC | |||||||||||
the power is turned | another unit’s SWITCHED AC OUTLET. | OUTLET. | |||||||||||
on. |
|
|
|
| Make sure to use the |
|
| (standby/on) button on | |||||
|
|
|
|
|
| ||||||||
|
|
|
|
|
| ||||||||
|
|
|
|
| this unit to turn on and |
| off. | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
•Even if the 
(standby/on) button is turned off, a small amount of sound may be heard from the headphones if the VOLUME control is set to max. This is normal.
3