Yamaha YST-SW005 owner manual Controls and Their Functions

CONTROLS AND THEIR FUNCTIONS

Front panel

SUBWOOFER SYSTEM YST-SW005

1 Port

POWER

ON

2

OFF

3

110V-120V VOLTAGE

Rear panel

	VOLUME
	0	10
AUTO	HIGH	HIGH CUT
STANDBY	LOW
HIGH
LOW
OFF
INPUT2		/MONO
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
	POWER
	ON
	OFF

		VOLUME
				8
		0	10
	AUTO	HIGH	HIGH CUT	9
4	STANDBY	LOW
	HIGH
	LOW
	OFF
5	INPUT2		/MONO
6	INPUT1
	FROM AMPLIFIER

220V-240V

SELECTOR

220V-240V	VOLTAGE
	SELECTOR
110V-120V

1Power indicator

Lights up GREEN when the POWER switch (2) is pressed in to the ON position and goes off when set to the OFF position.

*Standby mode

If the POWER switch (2) is pressed in to the ON position and the AUTO STANDBY switch (4) is set to the HIGH or LOW position, this indicator lights up RED when no signal is received by the subwoofer.

2POWER switch

Press this switch to the ON position to turn on the

power of the subwoofer. When the power of the subwoofer is on, the power indicator (1) on the front panel lights up GREEN. Press this switch again to set to the OFF position to turn off the power of the subwoofer.

3VOLTAGE SELECTOR switch

(China and General model only)

If the preset setting of the switch is incorrect, set the switch to the proper voltage range (220V-240V or 110V-120V) of your area.

Consult your dealer if you are unsure of the correct setting.

WARNING

Be sure to unplug the subwoofer before setting the VOLTAGE SELECTOR switch correctly.

E-8

	OUTPUT
7	TO SPEAKERS

4AUTO STANDBY (HIGH/LOW/OFF) switch

This switch is originally set to the OFF position. By setting this switch to the HIGH or LOW position, the subwoofer’s automatic power-switching function operates as explained on page 9. If you do not need this function, set to the OFF position.

*Make sure to change the setting of this switch only when the POWER switch (2) is in the OFF position.

5INPUT2 terminals

Used to input line level signals from the amplifier.

6INPUT1 (FROM AMPLIFIER) terminals

Used to connect the subwoofer with the speaker terminals of the amplifier.

7OUTPUT (TO SPEAKERS) terminals

Can be used for connecting to the main speakers. Signals from the INPUT1 terminals (6) are sent to these terminals.

8VOLUME control

Adjusts the volume level. Turn the control clockwise to increase the volume, and counterclockwise to decrease the volume.

9HIGH CUT (HIGH/LOW) switch Selects the high frequency cut off point.

Normally, it is set to LOW, however, you may set to HIGH if necessary. Refer to page 10.