Controls

Front Panel

1POWER Switch and Indicator: Press to power on the YST-SW20; the power indicator will light up. Press again to power off. Before powering on and off, turn down the VOLUME control.

2HIGH CUT Switch: This switch selects the high-cut filter

frequency: Set it to either LOW or HIGH.

3VOLUME Control: Use this control to set the volume level. Turn it clockwise to increase the volume, and counterclockwise to reduce it.

Auto Power On/Off Function

When powered on, if no input signal is received after 5–10 minutes, the power is switched off automatically. When an input signal is received, the power is switched back on automatically. This function works only when the power switch is in the on position.

Note: The power may switch off automatically when the input signal level is very low. If this does occur, increase the output level from the source device and reduce the YST-SW20 VOLUME control accordingly.

Rear Panel

4LINE 1 IN: This 3.5 mm stereo jack connection is for inputting line-level signals to the YST-SW20.

5LINE 1 OUT: This connection can be used to feed the input signal to other equipment.

6LINE 2: These RCA-pin jacks are for inputting speaker level signals to the YST-SW20. They can be connected directly to the speaker outputs of a stereo amplifier.

ACTIVE SERVO PROCESSING

Active Servo

SUBWOOFER SYSTEM YST-SW20

Technology

1

POWER

 

HIGH CUT

2

HIGH

LOW

 

VOLUME

3

 

LINE 2

LINE 1

L

IN

6

 

R

OUT

4

5

3