CONNECTIONS
Connecting to the INPUT1/OUTPUT terminals of the subwoofer
For connection, keep the speaker cables as short as possible. Do not bundle or roll up the excess part of the cables. If the connections are faulty, no sound will be heard from the subwoofer or the speakers, or both of them. Make sure that the + and – polarity markings of the speaker cables are observed and set correctly. If these cables are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other, because this could damage the subwoofer or the amplifier, or both of them.
■Before connecting
Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.
Good No Good
■How to connect:
1Loosen the terminal’s knob, as shown in the figure.
2Insert the bare wire.
3Tighten the knob.
4Test the firmness of the connection by pulling lightly on the cable at the terminal.
Red: positive (+)
Black: negative
U.S.A., Canada and Australia models only
Banana Plug conection are also possible.
1Tighten the terminal knob.
2Simply insert the banana plug into the terminal.
1Press and hold the terminal’s tab, as shown in the figure.
2Insert the bare wire.
3Release your finger from the tab to allow it to lock securely on the cable’s wire end.
4Test the firmness of the connection by pulling lightly on the cable at the terminal.
Red: positive (+)
Black: negative
Plug in the subwoofer to the AC outlet
After all connections are completed, plug in the subwoofer and other audio/video components to the AC outlet.
To AC outlet
To AC outlet
12