CONNECTIONS
Connecting to the INPUT1/OUTPUT terminals of the subwoofer
■Before connecting
Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.
Good No Good
Plug in the subwoofer to the AC outlet
After all connections are completed, plug in the subwoofer and other audio/video components to the AC outlet.
AUTO
STANDBY
HIGH
LOW
OFF
OUTPUT | INPUT PHASE |
TO SPEAKERS | 2 |
10mm 
INPUT 1
L /MONO
NORM REV
R
(3/8”)
FROM AMPLIFIER
VOLTAGE |
|
SELECTOR | POWER |
ON |
OFF
■How to connect
1Press and hold the terminal’s tab, as shown in the
figure below. | To AC outlet |
|
2Insert the bare wires.
3Release your finger from the tab to allow it to lock securely on the cable’s wire end.
4Test the firmness of the connection by pulling lightly on the cable at the terminal.
+
1
2
–
Notes
•Do not let the bare speaker wires touch each other, because this could damage the subwoofer or the amplifier, or both of them.
•For connection, keep the speaker cables as short as possible. Do not bundle or roll up the excess part of the cables. If the connections are faulty, no sound will be heard from the subwoofer or the speakers, or both of them.
•Make sure that the + and – polarity markings of the speaker terminals are observed and set correctly. If these cables are reversed, the sound will be unnatural and lack bass.
8