![](/images/new-backgrounds/1101871/10187119x1.webp)
•In a
•While standing in the operator’s position (behind the snow thrower) engage the auger.
•Allow the auger to remain engaged for approximately ten (10) seconds before releasing the auger control. Repeat this several times.
•With the engine running in the FAST position and the auger control lever in the disengaged “up” position, walk to the front of the machine.
•Confirm that the auger has completely stopped rotating and shows NO signs of motion.
IMPORTANT: If the auger shows ANY signs of rotating, immediately return to the operator’s position and shut off the engine. Wait for all moving parts to stop before readjusting the auger control cable.
•To readjust the control cable, loosen the hex jam nut on the auger control cable “Z” fitting.
•Rotate the coupling end of the cable counterclockwise to provide more slack.
•Retighten the hex jam nut. See Figure 7.
"Z" Fitting |
Jam Nut |
Make sure cable is straight |
Figure 7
•Repeat Auger Control Test to verify proper adjustment has been achieved.
Chute Clean-Out Tool
The chute
•Release both the Auger Control Lever and the Traction/Auger Control Lock Lever.
•Stop the engine by removing the ignition key.
•Remove the
•Use the
WARNING: Never use your hands to clean snow and ice from the discharge chute or auger housing
•Refasten the
•While standing in the operator’s position (behind the snow thrower), engage the auger clutch lever for a few seconds to clear any remaining snow and ice from the discharge chute.
Drift Cutters (if so equipped)
Drift cutters should be used when operating the snow thrower in heavy drift conditions.
On models so equipped, drift cutters are assembled to the auger housing inverted, for shipping reasons. Remove the carriage bolts by unthreading the hex nuts which secure them, and reinstall the drift cutters in their proper position before operating the snow thrower. See Figure 8.
If your unit is not equipped with drift cutters, contact Customer Support as instructed on page 2 for information regarding price and availability.
Drift |
Cutter |
Carriage Screws / |
Hex Nuts |
Figure 8
Tire Chains (if so equipped)
Tire chains should be used whenever extra traction is needed. If your unit is not equipped with tire chains, contact Customer Support as instructed on page 2 for information regarding price and availability.
10