FILM LOADING

1.Open the Back Cover by turning the Back Cover Release Ring around the Tripod Socket in the direction of "0" (Open) .

2.After opening out the Back Cover, remove the Take-up Spool from the lower Film Chamber by pulling out the lower Spool Stud Knob.

3.While pulling out the upper Spool Stud Knob, set the Take-up Spool in the upper Film Chamber.

CAUTION: Before loading the film, make sure the 35 mm Film Rewind Release Button (27} is reset all the way into its original position.

4.Pull out the lower Spool Stud Knob and place a new roll of film (standard

120roll film) into position in the lower

Film Chamber.4www.butkus.org

5.Pull the film leader gently and insert it into the slot on the Take-up Spool in the upper Film Chamber. Make sure the film leader is inserted into the wider one of the two slots and its edge is set flush against the spool flange.

6.Turn the Film Advance Knob until the arrow "start" mark on the film leader aligns with the triangular mark on the edge of the picture frame. Then close the Back Cover.