CONTROLS
Mower Deck Cut Height Lift Lever
The lifting lever is used to place the mower deck in the transport position or one of the 14 different cutting height positions.
The cutting height is set by placing a peg in the hole for the desired cutting height and the peg is then locked on the inside (hidden in the illustration) with the supplied pin.
1.To raise the deck to the transport position, pull the lever backward to the locked position to engage the transport position.
2.To lower the deck, pull the lock handle to the lifting lever and push forward toward the peg to engage the set cutting height.
3.The lifting lever can also be used to temporarily adjust the cutting height, such as when passing a minor bump in the lawn.
Some models are equipped with an optional foot assist pedal for ease of deck maneuvering.
IMPORTANT INFORMATION
The cutting height range is from 1½" (38 mm) to 5" (127 mm) in ½" (13 mm) increments. The heights are measured from the ground up to the blade tip with the engine not running.
IMPORTANT INFORMATION
Always use the high position to transport.
IMPORTANT INFORMATION
In order to obtain an even cutting height it is important that the air pressure in all four tires is the same 15 psi (1 bar).
1 | 4 |
| |
| 3 |
| 2 |
|
1.Transport Lock
2.Height selection peg
3.Lock handle
4.Lifting lever
Cut height lift lever
