Connections
1. Inputs
The XLR female and ¼ -inch TRS (Tip, Ring, Sleeve) input jacks are connected in paral- lel. Either may be used as an input (for connecting additional audio equipment). A Link connection can be made by using either the XLR female or ¼ -inch jacks. When using the Link feature always use a TRS (Tip, Ring, Sleeve) cable.
2. Outputs
Either the XLR male or ¼ -inch connections may be used (or both). They will have the same gain as long as the XLR connection remains balanced right into the power amplifier. The ¼ -inch may be used balanced or unbalanced and will have the same gain. Use of balanced ¼ -inch TRS (Tip, Ring, Sleeve) cables will maintain the balanced impedance ensuring proper hum rejection when used with balanced ¼ -inch inputs at amplifier end. The XLR connection will drive a higher level by 6dB before clipping compared to the ¼ -inch connection Either connection provides ample level for all common power amplifiers.
Specifications
Model | EP1 |
System Type | Processor |
Crossover Frequency | 125 Hz |
Delay/Phase | A 0-degrees |
| B 45-degrees |
| C 90-degrees |
| D 180-degrees |
| E 270-degrees |
Boost | Punch = 50 Hz |
| Round = 38 Hz |
Subsonic | -6dB rolloff point |
| Punch = 43 Hz |
| Round = 33 Hz |
Input Levels | Max 10 Vrms, +22 dBv |
| (with “Sub Level” at 0, |
| 3 db lower at boost frequency) |
| suggested 1.2 Vrms, +4 dBv |
Output Levels | XLR Max 18 Vrms, +25 dBv with 10k load |
| ¼ inch Max 9 Vrms, + 10 dBv with 10 k load |
Power Input | 120VAC 7.8VA |
Dimensions (DWH xbackW, inches) | 5.25 x 19 x 1.75 x 17.5 |
Dimensions (DWH xbackW, cm) | 13.4 x 48.3 x 4.5 x 44.5 |
Weight (lbs/kg) | 5.5/2.5 |
