Clearance Height

Aminimum clearance height of 650mm (251/2”) is required when installed above a built-in electric hob, or 700mm (271/2”) when installed above a built-in gas hob.

Aminimum clearance height of 685mm (27”) is required when installed above a slot-in electric oven, or 787mm (30 1/2”) when installed above a slot-in gas oven.

When installed between adjoining wall cabinets, the wall cabinets must not overhang the hob and the distance between the underside of the cabinet and the worktop must be 450mm. If the height of the wall cabinet is less than 450mm, a gap of 50mm must be maintained either side of the hob.

This cooker hood must not be installed above a cooking appliance with a high level grill.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Hob

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

A: Built-in Electric Hob:

650mm minimum clearance

B: Built-in Gas hob:

700mm minimum clearance

C: Slot-in Electric Cooker: 685mm minimum clearance

D: Slot-in Gas Cooker: 787mm minimum clearance

Unpacking

The fittings supplied to install this cooker hood can be found with the instruction book inside the packaging and consists of the following:

Ducting spigot Blanking plate Wall fitting template

Fitting Kit: 2 - Wall fixing brackets 4 - Plastic rawl plugs

4 - Wall bracket fixing screws

2 - Security washers

2 - Security nuts

Fitting the Wall Brackets

1.Using the paper template provided mark the hole positions on the wall for the bracket fixing screws.

2.Check that the hole differences are correct with a tape measure as stated on the template.

3.At this stage it is important to allow 15mm (1/2”) clear space above the cooker hood to enable it to be hooked onto the brackets and for subsequent removal for decorating or servicing.

4.Fit the brackets with the round ends facing downwards using the plastic rawl plugs and screws provided.

12