Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can install it under a close fitting sink unit or a
570- |
600 |
820 |
450 |
IN04 |
Proceed as follows:
-Remove the machine’s worktop by unscrewing the two front retaining screws, pull from the front and slide out the rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.
Levelling
Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.
Technical specifications
Dimensions | Width | 45 cm |
| Height with worktop | 85 cm |
| Height without worktop | 82 cm |
| Max depth | 63 cm |
| Max depth with open door | 115.9 cm |
|
|
|
Electrical connection: | Information on the electrical connection is given on the rating plate on the | |
Voltage | inner edge of the dishwasher’s door. |
|
Overall power |
|
|
Fuse |
|
|
|
|
|
Water supply pressure | Minimum | 50 kPa (0.5 bar) |
| Maximum | 800 kPa (8 bar) |
|
|
|
Capacity |
| 8 place settings |
|
|
|
This appliance complies with the following E.E.C. Directives:
-73/23 or 19.2.73 (Low Voltage Directive) and subsequent modifications;
-89/336 or 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.
For best results we recommend the use of Finish detergents, rinse aid and salt.
EASY
POURING
PACK
L I Q U I D G E L
P O W D E R
N EW | |
LE | N |
ACTIO | |
DOUB |
|
C O N C E N T R AT E D D I S H WA S H E R D E T E R G E N T | |
FOR A
BRILLIANT
SHINE
R I N S E
DE15
5
