Important!
The first time you use the washing machine, when you switch it on, it may display a blinking zero and give an audible warning signal. This is due to the fact that the washing machine has performed a washing cycle during the manufacturer’s inspection tests, and this cycle has not been erased after its completion.
•Delay start, a time value indicated in hours and selected by means of the relevant button.
The delay time is displayed for 5 seconds, then the duration of the selected programme reappears.
After you have pressed the START/PAUSE button, the countdown begins, and the delay time value decreases by one unit every hour.
You can delay the start of the selected programme by up to 24 hours in one hour intervals.
•An incorrect option selection has been made: this is indicated by the message Err when a function incompatible with the current programme is selected.
The incorrect selection is also indicated by an audible warning signal.
•An alarm code indicates a fault in the machine operation (see the relevant chapter on page 19).
E20
9 START/PAUSE button 
This button has three functions:
•Start: after you have selected the desired programme and options, press this button to start the washing machine. The light above the button will stop flashing and remain lit.
If you have selected a delay time by means of button 11, the countdown will begin and will be shown on the display.
•Pause: when you press this button again, the programme in progress is interrupted. The light above the button will start flashing. To restart the programme, press the button again.
When you PAUSE the cycle, the DOOR LOCKED light goes out, and it becomes possible to open the door, provided
•the washing machine is not in the heating phase;
•the level of the water is not high;
•the drum is not turning.
Important! You must set the washing machine to PAUSE before you make any change in the programme in progress.
•Draining of water and spinning after the execution of programmes with the RINSE HOLD option.
10 SKIP/RESET button
This button performs two functions:
-Clears the memory
-Selects special programmes
At the end of every programme the RESET button must be pressed once or repeatedly to clear the programme memory. This will be confirmed by three dashes, flashing in the display.
If the previous programme is not cleared, the display will show a “0” flashing and an audible signal will sound, when you switch the machine on.
Selecting a special programme:
A wash programme must be selected in the normal way. (START button not pressed)
ST | S | |
| ART/PAU | E |
|
| |
8
