5
XTRACAPACITY
DOOR OPEN ON-OFF
CONDENSER DRYER
ELECTRONIC SENSOR
A
EXTRA
DRY
B
STORE
DRY
C
LIGHTLY
DAMP
D
IRON
DRY
E
MACHINE
IRON DRY
F
EXTRA
DRY
G
STORE
DRY
H
LIGHTLY
DAMP
COTTON SYNTHETICS
H
TCS 675 EW
LOW
TEMP.
START
BUZZER
OFF
LOW
TEMP.
START
BUZZER
OFF
AUTOREVERSE
SELECTOR
IMPORTANT: PLEASE READ THE INSTRUCTION BOOK BEFORE USING THIS APPLIANCE AUTOREVERSE
12345681015
791112 13 14
1 Water Reservoir
When the tumble dryer is being used, the condensed
water is collected in a special container. To empty the
reservoir, please refer to “Maintenance” chapter.
2 Programme Chart
This will help you to select the correct programme for
drying.
3 Door open button
Depress this button to open the door.
Should the door be opened while appliance is
working, the tumble dryer will stop functioning.
Depress STARTbutton to resume drying after closing
the door.
4 ON-OFF Button
This button is used to switch the dryer on. At the end
of the programme, release this button by pressing it
again to switch the dryer off.
5 Mains-On Light
It comes on when the appliance is switched on (ON-
OFF button pressed down) and goes out when this
button is released.
6 Low Temperature Button
Pressing this button allows drying to be performed at
a lower temperature, for delicate items.
The corresponding pilot light 7 comes on and an
acoustic sound is heard.
This option can also be used for time controlled
drying.
7 Low Temperature Light
It comes on when the low temperature button is
pressed.
8 Buzzer OFF Button
A buzzer sounds when buttons 6-8 and 10 are pressed
and during the anti-creasing phase.
Press this button when selecting the programme if
you wish to switch the buzzer off.
When the water reservoir is full, the buzzer will
sound for 1 minute even if you have depressed
button .
9 Buzzer Off Light
It comes on when you press the corresponding button.
10 Start Button
Press this button for about 1 second to start the dryer
after having selected the drying programme. An
acoustic sound rings.
If the door is opened while the programme is
running, this button must be pressed again after
closing the door in order to re-start the
programme from the point at which it was
interrupted.
This button must also be pressed after a power cut
and after having re-inserted the water reservoir if it
has been emptied in the middle of the programme.
In both cases light or (depending on the phase
in progress) flashes to remind you that the start button
needs to be pressed again.
125994650.qxd 09/05/01 16.02 Pagina 5 (Nero/Process Black pellicola)