Problem
Water flows on the ground.
The temperature in the appliance is too low.
The temperature in the appliance is too high.
Possible cause
Products prevent that water flows into the water collector.
The melting water outlet does not flow in the evaporative tray above the com- pressor.
The temperature regulator is not set correctly.
The temperature regulator is not set correctly.
Solution
Make sure that products do not touch the rear plate.
Attach the melting water outlet to the evaporative tray.
Set a higher temperature.
Set a lower temperature.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the same time.
There is no cold air circulation in the appliance.
Refer to "Closing the door".
Let the product temperature decrease to room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula- tion in the appliance.
Replacing the lamp
Caution! Disconnect the plug from the mains socket.
1.Remove the screw from the lamp cov- er.
2. Remove the lamp cover (refer to the illustration).
3.Replace the used lamp with a new lamp of the same
power (the maximum power is shown on the lamp cover).
4.Install the lamp cover.
5.Tighten the screw to the lamp cover.
6.Connect the plug to the mains socket.
7.Open the door. Make sure that the light comes on.
Closing the door
1.Clean the door gaskets.
2.If necessary, adjust the door. Refer to "Installation".
3.If necessary, replace the defective door gaskets. Con- tact the Service Center.
Technical data
Dimension of the recess
Rising Time
Height
Width
Depth
1225 mm
560mm
550mm
12h
8
