Zanussi ZDI 6053 SX manual Washing programmes, Operating sequence

Washing programmes

Programme	Type of load and	Starting position	Required	Recommended					Cycle
	degree of soil	of the programme	push	quantity of detergent					description
		selector dial	buttons	wash	prewash
Intensive 70°C							Hot prewash
	Heavy soil.		Intensive				Main wash up to 70°C
	Crockery, cutlery, pots	A	+				2 cold rinses
				20 g	10 g
	and pans		On/Off			1		hot	rinse
							Active drying
Normal 65°C							Cold prewash
							Main wash up to 65°C
	Normal soil.
				25 g	5 g	1		cold rinse
	Crockery and cutlery	A	On/Off
						1		hot	rinse
							Active drying
							Cold prewash
* Bio 50°C							Main wash up to 50°C
			BIO
	Normal soil.
				25 g	5 g	1		cold rinse
	Crockery and cutlery	A	+
						1		hot	rinse
			On/Off
							Active drying
**Quick wash
	Light soil.
			BIO
							Main wash up to 50°C
50°C	Crockery and party
		B	+
				30 g	/		1 cold rinse
	crockery		On/Off			1		hot	rinse
Rinse and Hold	Partial load (to be
	completed later in the
		C	On/Off	/	/
							1	cold	rinse
	day).

* Testing programme for EN 50242 (see "Hints for Test Centres).
**This is a special programme for quick washing a full load of lightly soiled dishes, glasses and crockery (except pots) so that	you
may re-use them promptly.

Operating sequence

1. Check the filters

Ensure they are clean and properly positioned (see "Maintenance and cleaning" - Instruction book part 1).

2. Check that there is rinse aid and salt

(See "Instruction book - part 1")

3. Load the dishes

Remove any scraps of food.

Pull the lower basket out and arrange the saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.

Slide the baskets back into the machine.

4.Ensure that the spray arms can rotate freely

5.Measure out detergent

Add the required amount of detergent into the dispenser according to the "Washing programmes" chart.

Close the detergent dispenser lid.

6.Close the dishwasher door

7.Set the programme

Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker on the control panel.

If necessary select the temperature of the main wash according to the instructions given in the "Washing programmes" chart (see "Required push buttons").

8. Start the programme

Depress the On/Off push button.

The On/Off indicator light will come on and the machine will start.

If you wish to interrupt the washing programme at any time press this button again.

9. At the end of the washing programme

At the end of the programme the dishwasher will automatically stop.

The On/Off indicator light remains on until the On/Off push button is depressed.

10. Switch off the dishwasher

Switch off the dishwasher by pressing the On/Off push button and open the door.

Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.

When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.

In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops.

Important!

Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape.

3