WARNING!
Only use, for connection to the water mains,
new hose-set; old hose-set must not be reused.
CAUTION!
If the machine is connected to new pipes or
pipes which have not been used for a long time,
you should run the water for a few minutes be-
fore connecting the inlet hose.
Inlet hose
Connect the inlet hose to a water tap with an external
thread of 3/4”.
The inlet hose can be turned either to the left or the
right to suit the installation by means of the locknut.
The locknut must be correctly fitted to avoid water
leaks.
Drain hose
Connect drain hose to the
sink. Secure it with the
supplied hose clamp.
Required height: 30 to 100
cm above bottom of the
dishwasher.
Ensure that the hoses are
not kinked, crushed or en-
tangled.
When connecting the
drain hose to an under
sink trap spigot, the entire
plastic membrane (A)
must be removed. Fail-
ure to remove all the mem-
brane will result in food
particles building up over
time eventually blocking
the dishwasher drain hose
spigot.
22