Door Reversal
1.Close the cabinet and disconnect the appliance from the electricity socket.
2.Remove the ventilation grille. There is a part on the grille that can be removed. Reposition it and transfer to the opposite side.
3.Support the cabinet on a wooden block when it is laid down. This will make it easier to grip under the cabinet when returning to an upright position.
4.On the upper part of the cabinet. Remove the hinge pin and replace on the other side.
5.On the lower part of the cabinet. Unscrew the hinge. Move the hinge pin and plastic cover. Secure the hinge on the other side.
6.Raise the cabinet and replace the ventilation grille.
7.Unscrew the handle. Carefully press in the plastic plugs on the opposite side using a punch. Secure the handle in the plug holes. Then press the supplied plastic plugs into the holes to which the handle was previously fitted.
8.Put the cabinet in position. Check that it stands straight. See the section "Positioning the cabinet".
Attention
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
1 |
2 |
3 |
4 |
5
7 |
Zanussi 818 15
16
