Zanussi ZFC 35C Defrosting, Something Not Working, Internal Cleaning, External Cleaning

Defrosting Maintenance and Cleaning

The freezer compartment will become progressively covered with frost. This should be removed with the special plastic scraper provided whenever the thickness of frost exceeds 1 /4".

During this operation it is not necessary to switch off the power supply or to remove the foodstuffs.

However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to perform this operation when the appliance is empty.

)To carry out complete defrosting:

1.Disconnect the freezer from the electricity supply.

2.Remove any stored food, wrap in several layers of newspaper and store in a cool place.

3.Leave the lid open.

4.To accelerate the defrosting process place a bowl of hot (not boiling) water inside the freezer and close the lid.

5.When defrosting is completed, dry the interior thoroughly.

6.Turn the thermostat control back to a medium setting between 3-4 and leave to run for at least 2 hours.

7.Replace the previously removed food.

Important

A temperature rise of the frozen food packs during defrosting may shorten their safe storage life.

Never use sharp metal tools to scrape off frost from the evaporator as this could damage the appliance beyond repair.

Something Not Working

Before any maintenance or cleaning is carried out you must DISCONNECT the appliance from the electricity supply

Internal Cleaning

Clean the inside and accessories with warm water and bicarbonate of soda (5m1 to 0.5 litre of water).

Rinse and dry thoroughly.

NEVER use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as these will damage the surface and leave a strong odour.

External Cleaning

Wash the outer cabinet with warm soapy water.

When the Appliance is not in Use

When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the lid open to prevent unpleasant smells.

If the appliance is not working correctly, please carry out the following checks before calling out an engineer.

Defect:

Check if:

Possible cause:

Action:

Freezer not cold	Temperature of stored foods	Plug not connected correctly	Check plug and socket
enough	increases (becomes hotter).	Defect in switch or fuse	Check fuse, call electrician
		Power failure	Wait until power is restored
Too much frost formed	Lid does not close	Lid in contact with goods in	Re-arrange goods, check that
	completely	freezer	lid closes correctly
	Lot of moisture in the room	Moisture from washing	Move freezer to a room with
		machine, tumble-dryer, etc.	less moisture, or air regularly
	Goods packed poorly	Lot of moisture from goods	Re-pack goods, see under
			“How to use”

If after all above checks there is still a fault, contact your local Service Force Centre.

In-guarantee customers should ensure that the above checks have been made, as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for any in-guarantee service calls.

7