Zanussi ZHC 916X manual Fixing the chimney, Ducting or re-circulation fitting

INSTALLATION INSTRUCTIONS

Fixing the chimney

a)Loosen the screws M fixing the two parts of the chimney and pull the inner section I (Fig. 21) almost all the way out. Remove the protective film P.

b)Rest the lower section of the chimney in its housing on the top of the hood canopy. Lower the ducting fan unit until it reaches the wall bracket S and fix it using the screw H provided (Fig. 22).

Fit cover D provided on the wall bracket S (Fig. 23).

c)Fix the chimney A to the hood canopy C using four screws provided (Fig. 24).

d)Insert the transparent seal Q provided, so as to eliminate any play between the two parts of the chimney (Fig. 25). Lock the screws M.

e)Remove the support rod B.

Ducting or re-circulation fitting

1.Ducting fitting:

This is possible in all forms of installation.

a)Connect the air outlet to the external ducting system.

b)Remove the activated charcoal filter (if fitted)

inside the hood canopy (See Maintenance and Cleaning).

2.Re-circulation fitting:

This is only possible with the air outlet directed upwards. Fit the venting grille G onto the air outlet (Fig. 26). The activated charcoal filter should be fitted inside the hood canopy after connection.

26

I		21
	P
M
A08_20
	S	22
S		H
A08_21
D		23
	A08_22
E	E
E
B	E
		24
		25
Q	Q
	A08_24

17