Instructions for totally built-in appliances
Door reversal
The appliance is supplied with the door hinges on the right or on the left. To change the opening direction of the doors proceed as follows before installing the appliance.
1.Gently lay the appliance on its back with the top held away from the floor by
2Unscrew the upper pin and remove the spacer
3. Remove the upper door
4.Unscrew the pins (B) and the spacers (C) and refit them on the middle hinge of the opposite side. Snap the hinge cover (A).
5.Refit the upper door, the upper pin and the spacer on the opposite side
A |
C |
B |
6.Unscrew the lower pin and remove the spacer and refit them on the opposite side
Recess dimensions
Height | (1) | 1780 mm |
Depth | (2) | 550 mm |
Width | (3) | 560 mm |
To ensure adequate ventilation, allow the clearances shown in figure.
Furthermore, it is necessary that the cabinet has a ventilation recess with the following dimensions:
depth | 50 mm |
width | 540 mm |
16
50 mm | min. |
|
200 cm2 |
| |
|
| min. |
|
| 200 cm2 |
D567 |
|
|
| 50 |
|
540 |
|
|
| 3 |
|
| 2 | 1 |
PR01 |
|
|