A
B
C
D
PR266
5.Separate parts A, B, C, D as shown in the figure.
50mm | A |
PR166 |
|
6.Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied.
8mm |
A |
B |
PR167 |
8.Open the appliance door and the furniture door at 90¡. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with ¯ 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied.
PR168 |
9.Should the alignment of the furniture door be
necessary, use the clearance of slots. At the end of this procedure, it is necessary to check if the door of the furniture closes properly.
A
C
P R 3 3 / 2
7.Fix cover (C) on guide (A) until it clips into place.
B
D
PR167/1
10.Fix cover (D) on guide (B) until it clips into place.
17
