Door Reversal
Before carrying out the operations described below, pull out the mains plug from the wall socket.
To carry out this reversal go through the following steps:
1.Remove screws (A) which secure the worktop (B) on the back.
2.Lift the worktop (B) slightly, push it about 20 mm towards the rear, and lift it off upwards.
3.Unscrew the door hinge (C) and screw it into place on the opposite side.
4.Refit the worktop.
B |
A |
5.Gently lay the appliance on its back with the top held away from the floor by
6.Remove the bottom door hinge (E), unscrew the foot at the base (F) of the appliance and refit them on the opposite side..
7.Unscrew the handle (D). Refit it on the opposite side after having pushed in the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack.
When positioning the bottom hinge blade on the reverse side, the securing screws will require a degree of exersion when fitting.
It is therefore advisable to lubricate the screw tips before starting this operation.
Important
After completion of the door reversal operation, verify that the door gasket is sealing onto the cabinet.
If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
C
12
