Zanussi ZQS 6124 manual Technical Specifications, Installation, Positioning

Models: ZQS 6124

1 20
Download 20 pages 16.16 Kb
Page 12
Image 12
Technical Specifications

Technical Specifications

DIMENSIONS

Height

81,5

cm

 

Width

59,6

cm

 

Depth

54

cm

POWER SUPPLY VOLTAGE AND FREQUENCY

230-240 V / 50 Hz

 

TOTAL POWER ABSORBED

0,8 A

 

 

AVERAGE DAILY UNITS ELECTRICITY(*)

0,58 kWh

 

 

TOTAL GROSS CAPACITY

122 l

 

 

NET CAPACITY NET CAPACITY

STAR RATING

Fridge

102 l

compartment

17 l

(*)This figure is based on standard test results in accordance with European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located.

Installation

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.

Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions under “Door reversal”.

For building-in and door reversal instructions please refer to the relevant instructions on the following pages.

Important

It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.

Positioning

The appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located on the inside right of the appliance.

The following table shows which ambient temperature is correct for each climate classification.

SN

+10°C

to

+32°C

ST

+18°C

to

+38°C

The appliance should be located in a dry atmosphere, out of direct sunlight and away from continuous heat and extreme temperature, e.g. not next to a boiler or radiator or in a very cold room e.g. an outhouse. If these temperatures are exceeded i.e. warmer or colder, then the appliance may not operate correctly.

12

Page 12
Image 12
Zanussi ZQS 6124 manual Technical Specifications, Installation, Positioning