m1 m2
1
m5 m6
m3 m4
•Open the doors. Un- screw the middle hinge (m2). Remove the plas- tic spacer (m1).
•Remove the spacer
(m6) and move to the other side of the hinge pivot (m5).
•Remove the doors.
•Remove the
•Fit the pin of the middle hinge (m5) into the left- hand hole of the lower door.
•Unscrew the lower hinge (b1)
•Remove the
•
•Unscrew the lower hinge pivot (b2) and the spacer (b3) and place them on the oppo- site side.
•Remove the plugs (1) on the upper side of both doors and move them to the other side.
•
•Insert the middle hinge (m2) into the left drill of the lower door.
•Unscrew the upper hinge pivot and place it on the opposite side.
•Fit the upper door on the upper door pivot.
•
•
Do a final check to make sure that:
•All screws are tightened.
•The edges of the doors run parallel to the side edge of the appliance.
•The magnetic seal adheres to the cabinet.
•The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket.
Environmental concerns
In case you do not want to carry out the above men- tioned operations, contact the nearest After Sales Serv- ice Force. The After Sales Service specialist will carry out the reversibility of the doors at your cost.
The symbol 
on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product.
8
