Zanussi ZRD 7846 manual Door Reversal, Disconnect the appliance from the electricity supply

Door Reversal

Disconnect the appliance from the electricity supply.

Tilt back the appliance carefully. It is recommended to ask another person for help, who can keep the appliance at this position safely.

Unscrew on the both sides adjustable feet (2 pieces) and the fixing screws (2 pieces) of bottom door holder and the far side screws (2 pieces) too.

Take off the door of the refrigerator by pulling it slightly downwards.

Dismount the double door holder by removing the screws (2 pieces).

Take off the door of the freezer by pulling it slightly downwards.

Unscrew the top door holding pin of the freezer, then screw it back on the other side.

Remove the covering nails of the double door holder on the left side and put them to the other side.

Fit the door of the freezer to the top door holding pin.

Fix the double door holder onto the left side using the screws (2 pieces). Be careful that the door edge of the freezer is parallel with the edge of the mantle.

Fit the door of the refrigerator to the double door holding pin.

Fix the bottom door holder onto the left side using the screws (2 pieces) and the adjustable foot as well as screw the 2 pieces screws on the opposite side into the vacant holes. Be careful that the door edge of the refrigerator is parallel with the edge of the mantle.

Put over the handle on the opposite side and cover up the vacant holes with the plastic nails from the bag of instruction book.

After released the screws the adaptation of the doors can be adjusted with the horizontal control of central door holder.

Put the appliance to its place, set it level and connect to the electricity supply.

In case you do not want to perform the procedures above, call the nearest brand-mark service. Technicians will accomplish the refitting expertly for charge.

Important

After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating the part involved with a normal hairdryer on a low setting.

17