BUILDING-IN INSTRUCTIONS
Before carrying out any work, remove the plug from the power socket.
Grid preparation
Remove the grid from the appliance pulling it towards you with hands.
Right door opening:
Remove the left side (A) of the grid cutting it from the rear (see figure, a).
Left door opening:
Remove the right side (B) of the grid cutting it from the rear (see figure, b).
To reposition the grid on the appliance proceed as fol- lows:
Apply the grid to the base of the appliance by pushing the clasps (a) until they click.
N.B. The grid is to be assembled after having fixed the appliance in the niche with the brackets.
Door reversal
The appliance must be unplugged before starting work. To reverse the opening direction of the door, proceed as follows:
1.Remove the top hinge (1) taking care not to let the door fall;
2.remove the bottom door hinge (5).
3.take out the plugs (3) from the holes (F) and rein- sert them in the holes (F1) on the opposite side;
4.refit the upper hinge (1) on the opposite side, on the bottom (position A);
5.refit the door on the pin of the hige (1) in position A;
6.insert the pin of the unscrewed bottom hinge (2) in the upper hole (G) of the door, therefore fix the hinge on the top in position B.
Important
After completion of the door reversal operation, verify that the door gasket is sealing onto the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fit- ting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
| a |
| a |
S.I.001 |
|
A | a |
| |
| B |
| b |
S.I.002 |
|
F | F1 | |
1 | ||
B | G | |
| 3 | |
F | F1 | |
2 | ||
A | ||
| ||
S.I.003 |
|
16
