Replacing the LP Print Head (Continued)
Assembly
1. Route the print head cables under the latch shaft and plug the print head cables into the receptacles on the print head.
2. Hold the print head against the bracket while replacing the screws and washers; attach the ground wire using the right screw and washer. Use a #1 Phillips driver to tighten the screws.
3. | Slip the left end of the print head |
| spring into the left side of the latch |
| bracket; then slide the right end into |
| the other side. The angle of the “V” |
| fits into the indent on the top of the |
| print head bracket. |
4. | Align the latch bracket up to the top |
| case and ensure that the cable are not |
| bent or pinched. |
5. | Replace the four screws that hold the |
| latch bracket to the top case and use a |
| #1 Phillips driver to tighten them. |
6. | Clean the print head with the cleaning |
| pen. |
Reload media. Plug in the power cord, | |
turn on the printer and print a status report | |
to ensure proper function. | |
| 31 |
