Hook Up Your Cable (CATV) to the TV
Connect cable service to the TV
1 | Locate the Antenna/Cable jack on the back of | |
the TV. | ||
|
Connect the cable that runs from the wall
2 directly to this jack, according to the diagram to the right.
3 | Remove the back of the remote and put in two | |
AA batteries. | ||
|
TV back
Cable TV wall jack
ANTENNA
back of remote
4 | Plug in the TV. Do not plug it into a switched | |
outlet. The TV is designed to operate on | ||
| ||
| household current, | |
| not attempt to operate it on DC Current. |
120 V AC
60 Hz
5 | Go to page 12 to Auto Program the TV. |
|
RF coaxial wire (75ohm)
Cable TV wall jack
CABLE
VIDEO MATRIX
IN OUT
M.P.I.
R- AUDIO- L
IN
TV back
If you’re using a cable box, leave the TV on channel 3 or 4 and use your cable box to change channels.
If you’re using a cable box, Auto Program might only find the channel your cable service is on (usually channel 3 or 4). Don’t worry, that’s all you need!
In | Cable box |
|
|
Out | output |
|
|
switch 3 4 |
|
| |
|
|
| |
| RF coaxial wire (75ohm) | ANTENNA |
|
| CABLE |
| |
|
| VIDEO | MATRIX |
|
| IN | OUT |
M.P.I.
R- AUDIO- L
IN
P A G E 8 |