Hook Up Antenna and VCR to the TV
Connect an
1 | Locate the Antenna/Cable jack on the back of the VCR. |
2 | Connect the cable that runs from the antenna directly to |
| this jack, according to the diagram to the right. As |
| required, make the other connections as shown to the |
| right. |
3 | Remove the back of the remote, put in two AA batteries. |
back of remote
4 | Plug in the TV. Do not plug it into a switched outlet. The |
| TV is designed to operate on standard current, |
| 60 Hertz AC. Do not attempt to operate it on DC Current. |
| 120 V AC |
| 60 Hz |
5 | Go to page 12 to Auto Program the TV. |
No A/V cables are included with the Zenith TV.
Without A/V cables, most VCRs will not play videocas- settes in stereo sound.
Antenna
Flat wire (300 ohm)
300/75 ohm Adapter
TV back
ANTENNA
CABLE
VIDEO MATRIX
IN OUT
M.P.I.
R- AUDIO- L
IN
TV back panel (expanded view)
A/V cables not included with TV
Antenna
| RF coaxial wire | |
| (75ohm) | |
TV back | RF coaxial wire | |
| (75ohm) | |
TV back | not included | |
with TV | ||
|
ANTENNA
CABLE
VIDEO MATRIX
IN OUT
M.P.I.
R- AUDIO- L
IN
TV back panel (expanded view)
A/V cables not included with TV
VCR back
VCR back AV panel
In output 
switch 3 4
Out Video Audio
VCR back
VCR back AV panel
In output 
switch 3 4
Out Video Audio
P A G E 9 |