9. Maintenance
ANGLE TRANSMISSION
•The reduction gears are lubricated by multipurpose,
•Remove the bolt of the grease nipple and the bolt opposite side of the grease nipple. Install new grease into the grease nipple to arrange for old grease to exit from the opposite side.
(1)
(1) Grease
FLEXIBLE SHAFT
1.Pull out the flexible liner while pulling the stopper up- ward.
(1) Stopper
(2) Flexible liner
(3) Clutch housing
2.Pull out the inner shaft from the clutch housing side hole, apply Zenoah Guine Power Grease (Z3180- 91250) or
(4)Inner shaft
3.Replace the inside seal at the grip side of the flexible shaft.
BKZ4505DL / BKZ5010DL
INTAKE AIR COOLING VENT |
| ||
|
|
|
|
WARNING |
|
|
|
• Check the intake air cooling vent after every 25 | G | ||
hours of use for blockage, and remove any waste | B | ||
which has attached itself to the brushcutter. |
| ||
|
|
|
|
IMPORTANT |
|
| |
•If waste gets stuck and causes blockage around the intake air cooling vent, it may cause the engine to over- heat, and that in turn may cause mechanical failure on the part of the brushcutter.
(1)
(1) (1) Intake air cooling vent
■PERIODICAL SERVICE POINTS 1. CYLINDER FINS
Periodically check and clean the cylinder fins in the re- pair specialty store.
10. Storage
Aged fuel is one of major causes of engine starting fail- ure. Before storing the unit, empty the fuel tank and run the engine until it uses all the fuel left in the fuel line and the carburetor. Store the unit indoor taking necessary measures for rust prevention.
