Cutting the limbs of Fallen Tree
First check to which side the limb is bent. Then make the initial cut from the bent side and finish by sawing from the opposite side.
Be alert to the springing back of a cut limb.
Pruning of Standing Tree
Cut up from the bottom, finish down from the top.
G3801/G3801EZ
•Do not use an unstable foothold or ladder.
•Do not overreach.
•Do not cut above shoulder height.
•Always use both your hands to hold the saw.
G
B
7. Maintenance
Before cleaning, the inspecting or repairing the unit, make sure that engine has stopped and is cool. Disconnect the spark plug to prevent accidental starting.
3. Guide bar
When the guide bar is dismounted, remove sawdust in the bar groove and the oiling port.
Grease the nose sprocket from the feeding port on the tip of the bar.
■MAINTENANCE AFTER EACH USE
1. Air filter |
| Grease port |
Dust on the cleaner surface can be removed by tapping a | Oiling port | Sprocket |
corner of the cleaner against a hard surface. To clean dirt in |
|
|
the meshes, split the cleaner into halves and brush in gaso- |
|
|
line. When using compressed air, blow from the inside. |
|
|
To assemble the cleaner halves, press the rim until it clicks.
Note: When installing the main filter, make sure that the grooves on the filter edge are correctly fit with the projections on the cylinder cover.
2. Oiling port
Dismount the guide bar and check the oiling port for clogging.
Oiling port
4. Others
Check for fuel leakage and loose fastenings and damage to major parts, especially handle joints and guide bar mounting. If any defects are found, make sure to have them repaired before operating the saw again.
■PERIODICAL SERVICE POINTS
1. Cylinder fins
Dust clogging between the cylinder fins will cause overheat- ing of the engine. Periodically check and clean the cylinder fins in the repair specialty store.
