Zenoah HTZ7510, CHTZ6010 owner manual Operation, English

F1

English

5. OPERATION

■ STARTING THE ENGINE

WARNING

Keep the blades clear of everything around It as they will start moving upon the engine starts.

1. [HTZ7510] Make sure that the throttle lever is at idling position. [CHTZ6010] Release the throttle lever and make sure it is fully back. (F1)

2. [CHTZ6010] Set the engine switch to the “I (RUN)” position. (F1)

3. Push the primer pump until overflown fuel flows out in the clear tube. (F2)

4. Move the choke lever to the closed position. (F3)

		(1)	Throttle lever	(7) Stop
		(2)	Full throttle	(8) Primer pump
		(3)	Idling (start position)	(9) Clear tube
		(4)	Stop switch	(10)	Choke lever
		(5)	Engine switch	(11)	Open
F2		(6)	Run	(12)	Close
		5. Place the unit on a flat, firm place.
			Keep the cutting head clear of
	(8)		everything around it.
		6. While holding the unit firmly, pull
			out the starter rope quickly. (F4)

	IMPORTANT
	•	Avoid pulling the rope to its end or
		returning it by releasing the knob.
		Such actions can cause starter
F3		failures.
	7.	Move the choke lever downward
		to open the choke. and restart
		engine. (F3)
	8.	Allow the engine to warm up for a
		several minutes before starting
		opertion.
		NOTE
	1.	When restarting the engine
		immediately after stopping it,
		leave the choke open. (F3)
F4	2.	Overchoking can make the engine
		hard to start due to excess fuel.
		When the engine failed to start
		after several attempts, open the
		choke and repeat pulling the rope,
[HTZ7510]		or remove the spark plug and dry
		it.
	■ STOPPING THE ENGINE (F1)
	[HTZ7510]
	1.	Please return the throttle lever
		completely.
	2.	Press the stop switch until the
		engine comes to a complete stop.
	[CHTZ6010]
[CHTZ6010]	1.	Release the throttle lever.
	2.	Move the engine switch to the
		“O(STOP)”position.
		NOTE
	If the engine doesn’t stop after
	stopping the switch, close the choke
	so that engine will stop after a little.
14