Checking the LEDs

Look at the LEDs at the front panel of the AMG1202-T10A.

•The POWER LED blinks during start-up and is green once the AMG1202-T10A is ready.

•Each ETHERNET LED turns on if the corresponding ETHERNET port is properly connected. The LEDs blink when the AMG1202- T10A is sending or receiving data through the corresponding ETHERNET port.

•The DSL LED stays on if a physical DSL connection exists.

•The INTERNET LED is green when Internet access is available and blinks when transmitting data.

•The WLAN/WPS LED stays green when the wireless LAN is ready. It blinks when the AMG1202-T10A is sending/receiving data through the wireless LAN.

If none of the LEDs are on, check your connections. Make sure that you have the power adaptor connected to the AMG1202-T10A and plugged into an appropriate power source. Make sure the power source is turned on. Turn the AMG1202-T10A off, wait for a few seconds and turn it back on. If the LEDs are still off, contact your local vendor.

6