ZyAIR B-500 802.11g Wireless Access Point

3.Adjust the cables.

a.Run the connection cables down the back of the ZyAIR.

OR:

b.Run the connection cables upward and along the edge of the ceiling.

4.Align the holes on the back of the ZyAIR with the screws on the wall. Hang the ZyAIR on the screws.

6 Troubleshooting

PROBLEM

CORRECTIVE ACTION

 

 

The PWR/SYS

Make sure you are using the correct power adaptor and the power adaptor is

LED is off.

plugged into an appropriate power supply.

 

Unplug the power adaptor and plug it in again. If the error persists, you may have a

 

hardware problem. In this case, you should contact your vendor.

 

 

The ETHN LED is

Check the cable connection to the ZyAIR ETHERNET port.

off.

Make sure your computer’s network card is working properly.

 

 

 

I cannot access

Make sure the IP addresses and subnet masks of the ZyAIR and the computer are

the web

in the same IP address range. (For example, if the ZyAIR is using the default IP

configurator.

address and subnet mask, check that the IP address of the computer is in the range

 

192.168.1.3 ~192.168.1.254 and the subnet mask is 255.255.255.0). Refer to the

 

Setting Up Your Computer’s IP Address section.

 

If you change the ZyAIR default IP address, then enter the new IP address as the

 

web site address.

 

The default password is “1234”. If you have changed the password and have now

 

forgotten it, you will need to reset the ZyAIR. Refer to the User’s Guide for how to

 

use the RESET button.

I cannot ping any

If the ETHN LED is off, check the cables between the ZyAIR and your computer or

computer on the

hub.

wireless LAN.

Verify that the IP address and the subnet mask of the ZyAIR and the computers are

 

 

in the same range.

 

 

13