ZyWALL IDP 10 Quick Start Guide
Table 2 Rear Panel Power Connection
LABEL | DESCRIPTION |
| |
|
|
|
|
|
|
|
|
WARNING: Using an incorrect power adapter will damage your device!
After you’ve made the connections, use the power cord to connect the power adaptor to a power source and look at the front panel LEDs.
4.3 The Front Panel LEDs
Figure 5 Front Panel LEDs
The PWR LED turns on when you first connect the power. The SYS LED blinks while performing system testing and then stays on if the testing is successful. The WAN, LAN and MGMT LEDs turn on if the corresponding connections are properly made. Refer to the following table for more detailed LED descriptions.
Table 3 Front Panel LEDs
LED | COLOR | STATUS | DESCRIPTION | |
|
|
|
| |
PWR |
| Off | The ZyWALL IDP is turned off. | |
|
|
|
| |
| Green | On | The ZyWALL IDP is turned on. | |
|
|
|
| |
| Red | On | The power to the ZyWALL IDP is too low. | |
|
|
|
| |
SYS | Green | Off | The ZyWALL IDP is not ready or has failed. | |
|
|
|
| |
|
| On | The ZyWALL IDP is ready and running. | |
|
|
|
| |
|
| Blinking | The ZyWALL IDP is restarting. | |
|
|
|
| |
WAN |
| Off | The WAN connection is not ready, or has failed. | |
10/100 |
|
|
| |
Green | On | The ZyWALL IDP has a successful 10Mbps WAN | ||
| ||||
|
|
| connection. | |
|
|
|
|
9