ZyXEL Communications ONU5100-B22 Specifications, Safety Warnings

If you cannot connect to the Internet, make sure the OLT has Internet access and the ONU5100-B22 is registered with the OLT successfully.

If the ONU5100-B22 cannot register with the OLT,

•Check the connector on the optical cable and the PON port. Make sure they are clean and dust-free. Use an air duster to clean the connectors. Do NOT use a wet cloth to clean the connectors.

•Check the optical cable. Make sure it is not broken. If the cable is broken, contact your service provider to have the cable/connector replaced.

Specifications

Specifications are accurate at the time of writing.

Feature	Specification
Dimensions (mm)	75 (Wide) x 14 (Deep) x 12.4 (High)

Weight	< 1 kg

Power Supply	+ 3.3V

Power Consumption	< 2 W

Case Operation	0 ºC ~ 70 ºC
Temperature

Storage	-40 ºC ~ 85 ºC
Temperature

Feature	Specification
Operation Humidity	0% ~ 85% (non-condensing)

Storage Humidity	0% ~ 95% (non-condensing)

PON Interface	One PON port (single fiber link)
	Compliant with IEEE 802.3ah
	PX-20
	SC optical connectors with shutters
	Transmission distance: 20 km
	Wavelength: 1310 nm upstream and
	1490 nm downstream
	Full duplex

Safety Warnings

•Ground yourself (by properly using an anti-static wrist strap for example) whenever working with the device's hardware or connections.

•Do NOT use this product near water, for example, in a wet basement or near a swimming pool.

•Do NOT expose your device to dampness, dust or corrosive liquids.

•Do NOT store things on the device.

•Do NOT install, use, or service this device during a thunderstorm. There is a remote risk of electric shock from lightning.

•Connect ONLY suitable accessories to the device.

•Do NOT open the device or unit. Opening or removing covers can expose you to dangerous high voltage points or other risks. ONLY qualified service personnel should service or disassemble this device. Please contact your vendor for further information.

•Make sure to connect the cables to the correct ports.

•Place connecting cables carefully so that no one will step on them or stumble over them.

•Always disconnect all cables from this device before servicing or disassembling.

•Use ONLY an appropriate power adaptor or cord for your device.

•Do not use the device outside, and make sure all the connections are indoors. There is a remote risk of electric shock from lightning.

•Make sure that the cable system is grounded so as to provide some protection against voltage surges.

Your product is marked with this symbol, which is known as the WEEE mark. WEEE stands for Waste Electronics and Electrical Equipment. It means that used electrical and electronic products should not be mixed with general waste. Used electrical and electronic equipment should be treated separately.