ZyXEL Communications P-202H Plus v2 3 Initial Configuration

P-202H Plus v2 Quick Start Guide

4POWER: Use the power adaptor provided with your P-202H Plus v2 to connect an appropriate power source to this port. Make sure the power source is on.

5Push in the POWER button. Look at the LEDs on the front panel.

•The POWER LED blinks while your P-202H Plus v2 starts up and stays on once the system is ready.

•The ISDN and ETHERNET LEDs stay on if the corresponding port is properly connected and blinks when there is traffic.

If any of these LEDs are not on, check your connections, and inspect your cables for damage. If the LEDs are still off, contact your local vendor.

3 Initial Configuration

1Open your web browser, and go to http://192.168.1.1.

2The login screen displays. Enter the password (“1234” is the default) and click Login.

Note: If the login screen does not display, check your browser’s security settings (see Troubleshooting for details) or make sure your computer is set to receive an IP address dynamically (see Set Up Your Computer’s IP Address).

3Type a new password, re-type it to confirm, and click Apply. (The next time you log in, you should not see this screen.

4You should now see the Site Map screen.

3