ADIC SNC 5100, Scalar 1000 manual FcShowDevs

		SNC 5100
Table 4-1: Post-Repair Checklist
Step	Actions		Comments and References
10	From the service		In the output of the fcShow command, look for the
	terminal, enter the		Firmware State column.
	fcShow command to
	show the status of each		If the word Ready does not appear, go to “Fibre
	FC interface that is		Channel MAP” on page 61.
	installed and connected.
			Check to see that all SCSI target devices are seen by
	From the service		each FC interface.
	terminal, enter the
	fcShowDevs		If not, go to “SCSI Channel MAP” on page 50.
	command to show the
	SCSI target devices that
	are connected as seen by
	the Fibre Channel
	interface.
11	Verify that all (or the		Use appropriate host system utilities for tape.
	designated) target		See Table 4, “Host Utility Software,” on page 23.
	devices are available to
	the host systems.		If “Access Control” is enabled (Channel Zoning or
			SFM) the hosts will only see the devices that have
			been assigned to them.
			If the designated devices are NOT available, reboot
			the host and check again.
			If the problem persists, go to “Start MAP” on page 42.
12	Disconnect the RS-232		None.
	cable from the and from
	the service terminal.
13	End of repair.

Post-Repair Checklist 93

6-00020-02