ADIC SNC 5100 SfmAccessClear disable code, SfmAccessSet hostindex,Starting LUN,Ending LUN,Access

SNC 5100

sfmAccessClear [disable code]

The sfmAccessClear command disables all host access to all LUNs except to LUN 0 (the Command and Control interface). The disable code is 0xfacade02.

The following command example shows how to disable all access.

SN60023 >sfmAccessClear 0xfacade02 value = 0 = 0x0

SN60023 >

sfmAccessSet [hostindex],<Starting LUN>,<Ending LUN>,<Access>

The sfmAccessSet command sets the access for the specified range of LUNs for the specified host connection index.

Access Value
0	Disables access to the LUNs
1	Enables access to the LUNs

When you enter this command, the settings are stored in memory but are not applied until you enter the sfmAccessApply command. The following example shows how to enable the host at connection index 1 to access LUNs 2 through 32. Existing hostindex values can be determined by looking at the “Id” column in the output of the sfmShow -1command.

SN60023 > sfmAccessSet 1,2,32,1 value = 0 = 0x0

SN60023 >

sfmActiveSet

The sfmActiveSet command places SFM in the active state. The means that all of the current access settings are put into effect. You would typically only use this command after making SFM inactive. See the sfmInactiveSet command.

SN60023 > sfmActiveSet value = 0 = 0x0

Commands 165

6-00020-02