Cypress CY7C2563KV18, CY7C2561KV18 TAP Electrical Characteristics, TAP Controller, Gnd ≤ Vi ≤ Vdd

PRELIMINARY	CY7C2561KV18, CY7C2576KV18
	CY7C2563KV18, CY7C2565KV18
Figure 3. TAP Controller Block Diagram

TDI

TCK

Selection Circuitry

0

Bypass Register

2 1 0

Instruction Register

31 30 29 . . 2 1 0 Identification Register

108 . . . . 2 1 0

Boundary Scan Register

Selection Circuitry

TDO

TMS

TAP Controller

TAP Electrical Characteristics

Over the Operating Range [14, 15, 16]

Parameter	Description	Test Conditions	Min	Max	Unit
VOH1	Output HIGH Voltage	IOH = −2.0 mA	1.4		V
VOH2	Output HIGH Voltage	IOH = −100 μA	1.6		V
VOL1	Output LOW Voltage	IOL = 2.0 mA		0.4	V
VOL2	Output LOW Voltage	IOL = 100 μA		0.2	V
VIH	Input HIGH Voltage		0.65VDD	VDD + 0.3	V
VIL	Input LOW Voltage		–0.3	0.35VDD	V
IX	Input and Output Load Current	GND ≤ VI ≤ VDD	–5	5	μA

Notes

14.These characteristics pertain to the TAP inputs (TMS, TCK, TDI and TDO). Parallel load levels are specified in the Electrical Characteristics Table.

15.Overshoot: VIH(AC) < VDDQ + 0.35V (Pulse width less than tCYC/2), Undershoot: VIL(AC) > −0.3V (Pulse width less than tCYC/2).

16.All Voltage referenced to Ground.

Document Number: 001-15887 Rev. *E Page 16 of 29

[+] Feedback