3Remove all tape between the rollers and knives (see Figure 162).
[162] Remove the tape
4Insert a new trailing strip of tape between the rollers and the knives. For complete information refer to ‘Change the tape roll in the reinforcement unit’ on page 196.
No reinforcement strips on the output without an error message
This error occurs when there are no reinforcement strips on the output although reinforcement is selected. This can happen when the file header (Remote Control Format or Océ Job Ticket) contains instructions to have no reinforcement.
Note: If you want to process A4 formats, reinforcement can be disabled for this format.
▼To solve this error
1Press the Stop key on the operator panel twice.
2Open the side door of the Reinforcement unit.
238 | Océ TDS800 User Manual |
