LightSpeed Technologies X12, Delta X10 manual CD Player Operation, Low +

Operating Instructions

CD Player

Delta X10

Wireless

Sound System

	WIRELESS MIC 1				WIRELESS MIC 2
				REPEAT	A — B	STOP PLAY/PAUSE PROG
		CD-ROM ART GOES HERE
	NO diSC			EJECT	— SKIP —		SCAN/SEARCH
LINE	LINE/CD LEVEL		VOICE OVER MUSIC			TONE CONTROL
I						0	0
N
O
U			-dB40	dB0	–	LOW +	– HIGH +
T	min	max
	IN	LEVEL			IN	LEVEL
1				LOW CUT			LOW CUT
MIC				music speech			music speech
	min	max			min	max
MASTER				BATTERY	LOW CUT		LOW CUT
VOLUME				STATUS
LIMIT					music speech		music speech
	min	max		LOW OK
					WIRELESS		WIRELESS
		LEVEL				MIC 1	MIC 2

REPEAT A — B STOP PLAY/PAUSE PROG

CD-ROM ART GOES HERE

NO diSC EJECT — SKIP — SCAN/SEARCH

MIC 2

EXTERNAL

SPEAKER A

SWITCHED 8 OHM

EXTERNAL	LightSPEED				CHARGING STATUS
SPEAKER B	MADE IN EUROPE		EXTERNAL
8 OHM
			POWER
			SOURCE
			12VDC/4A
			4	1
ON MUTE			3	2	GND
			+ 12V
POWER	DO NOT OPEN	ACTIVE	MAINS
	THE COVER.	LINK		AC
ON	REFER SERVICING		90-264V
	TO QUALIFIED
OFF	PERSONNEL.		47-63Hz
	REPLACE FUSE		FUSE
	ONLY WITH
MUTE	THE SAME TYPE			T2A
	AND RATING.

		Voice
	Line/CD	Over	Tone
Line IN	Level	Music	Control
	1	2	3

LINE	LINE/CD LEVEL		VOICE OVER MUSIC		TONE CONTROL
I					0	0
N
O
U			- 40	0	–	+ –	+
T	min	max	dB	dB	LOW	HIGH

CD PLAYER OPERATION

Note: Detailed information about using the CD player is provided later in this manual.

1.Volume Adjustment (LINE/CD LEVEL): While playing a disc, slowly turn up the LINE/CD LEVEL control until you reach the desired volume. Remember that if the MASTER VOLUME is turned all the way down, no sound will come from the system regardless of the setting on the LINE/CD LEVEL control.

2.Voice Priority (VOICE OVER MUSIC): Audio coming from the CD player and the LINE IN jacks will automatically drop in level when sound is produced at any of the microphone inputs. When there is no more sound at the mic input(s), the audio from the CD player and/or the LINE IN jacks will come back to its original level. Adjusting the VOICE OVER MUSIC control changes the amount of drop in level that occurs when there is sound at the mic input(s).

3.Tone Controls: The LOW and HIGH tone controls can be used to cut or boost the lows and highs in the audio coming from the CD player and the LINE IN jacks. These controls do not affect the audio coming from the microphone inputs.

LightSPEED Technologies • Wireless Sound Solutions • Toll Free: 1-800-840-3662 14