Multiquip AR13D manual Rear Drum Removal/Installation

AR13D RIDE-ON ROLLER — MAINTENANCE

STEP 2

STEP 3 STEP 1

1.JACK FRAME UP SLIGHTLY AT ARTICULATION JOINT.

2.REMOVE THE FOUR ALLEN HEAD SCREWS SECURING THE DRUM SUPPORT PLATE TO THE FRAME.

3.REMOVE NUTS SECURING BEARING FLANGE TO BASE OF DRUM SUPPORT PLATE.

7.REMOVE TWO NUTS SECURING DRUM SUPPORT PLATE TO FLANGE. PULL OFF LEFT DRUM SUPPORT PLATE AND SET ASIDE.

8.PULL FLANGE OFF DRUM ROD FOR SERVICE.

9.PULL RIGHT DRUM SUPPORT PLATE OFF DRIVE PLATE ASSEMBLY.

STEP 8

STEP 7

Figure 39. Rear Drum Removal/Installation

STEP 6

STEP 4

I	STEP 5 J
	STEP 4

4.REMOVE ALLEN HEAD SCREWS HOLDING THE SIDE COVER OF THE DRUM SUPPORT PLATE.

5.MARK AND DISCONNECT HOSES FROM MOTOR.

6.REMOVE FOUR ALLEN HEAD SCREWS FROM DRUM SUPPORT PLATES.

STEP 10

STEP 9

STEP 11

10.REMOVE FOUR ALLEN HEAD SCREWS SECURING MOTOR TO DRUM SUPPORT PLATE AND SET ASIDE.

11.REMOVE SIX BOLTS SECURING DRIVE PLATE TO DRUM WALL. PULL OFF DRIVE PLATE AND SET ASIDE.

12.REVERSE PROCEDURES TO REASSEMBLE DRUM.

AR13D RIDE-ON TANDEM DRUM ROLLER — OPERATION & PARTS MANUAL — REV. #2 (09/15/11) — PAGE 35